Kia Soul: Blower Motor Replacement - Blower - Heating,Ventilation And Air ConditioningKia Soul: Blower Motor Replacement

Kia Soul 2014-2019 PS Service Manual / Heating,Ventilation And Air Conditioning / Blower / Blower Motor Replacement

[Standard Type]
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad Lower Panel")
3.
Remove the driver's side shower duct (A) after loosening the screw.
55555
4.
Lower the steering column after loosening the mounting bolts and nuts.
(Refer to Steering System - "Steering Column and Shaft")
5.
Disconnect the mode control actuator connector (A) and then remove the mounting clip (B).
6.
Disconnect the connector (A) and then remove the temperature control actuator (B) after loosening the mounting screws.
7.
Remove the brake pedal.
(Refer to Brake System - "Brake Pedal")
8.
Disconnect the connector (A) and then remove the blower motor (B) after loosening the screws.
9.
Install in the reverse order of removal.
[Telemetics Unit (TMU) Type]
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad Lower Panel")
3.
Remove the driver's side shower duct (A) after loosening the screw.
4.
Lower the steering column after loosening the mounting bolts and nuts.
(Refer to Steering System - "Steering Column and Shaft")
5.
Remove the telemetics unit (TMU).
(Refer to Body Electrical System - “Telemetics Unit (TMU)”)
6.
Disconnect the mode control actuator connector (A) and then remove the mounting clip (B).
7.
Disconnect the connector (A) and then remove the temperature control actuator (B) after loosening the mounting screws.
8.
Remove the brake pedal.
(Refer to Brake System - "Brake Pedal")
9.
Disconnect the connector (A) and then remove the blower motor (B) after loosening the screws.
10.
Install in the reverse order of removal.
    Blower Motor Inspection
    1. Connect the battery voltage and check the blower motor rotation. 2. If the blower motor does not operate well, substitute with a know ...

    Blower Resistor (Manual) Inspection
    1. Measure the resistance between the terminals. 2. The measured resistance is not within specification, the blower resistor must be replac ...

    See also:

    Description
    The starting system includes the battery, starter, solenoid switch, ignition switch, inhibitor switch (A/T), clutch pedal switch (M/T), ignition lock switch, connection wires and the battery ...

    Adding equipment to or modifying your air bag-equipped vehicle
    If you modify your vehicle by changing your vehicle's frame, bumper system, front end or side sheet metal or ride height, this may affect the operation of your vehicle's air bag system. ...

    CVVT & Camshaft Description
    Continuous Variable Valve Timing (CVVT) system advances or retards the valve timing of the intake and exhaust valve in accordance with the ECM control signal which is calculated by the engine ...