Removal
1. |
Turn the ignition switch OFF and disconnect the negative (-) battery cable.
|
2. |
Disconnect the accelerator position sensor connector (A).
|
3. |
Remove the mounting nuts (B).

|
4. |
Remove the cap (A)

|
5. |
Remove the mounting bolt (A), and then remove the accelerator pedal module.

|
installation
1. |
Install in the reverse order of removal.
Accelerator pedal module mounting nut:
12.8 ~ 15.7 N.m (1.3 ~ 1.6 kgf.m, 9.4 ~ 11.6 lb-ft)
Accelerator pedal module mounting bolt:
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)
|
|
Removal
1.
Open the fuel filler door and unfasten the filler-neck assembly mounting bolts (A).
...
See also:
Reducing the risk of a rollover
This multi-purpose passenger vehicle is defined as a Crossover Utility Vehicle
(CUV). CUV’s have higher ground clearance and a narrower track to make them capable
of performing in a wide variety ...
Components and Components Location
Component Location
1. Auto light sensor2. Head lamps3. Lighting switch (Auto)4. Tail lamps5. BCM (Body Control Module)
...
Connecting a Device
Press the
key
Select [Phone]
Select [Phone List]
1) Connected Phone : Device that is currently connected
2) Paired Phone : Device that is paired but not connected
From the paired ph ...