Kia Soul: Windshield Wiper-Washer Switch - Windshield Wiper/Washer - Body Electrical SystemKia Soul: Windshield Wiper-Washer Switch

Kia Soul 2014-2019 PS Service Manual / Body Electrical System / Windshield Wiper/Washer / Windshield Wiper-Washer Switch

Inspection

Check for continuity between the terminals while operating the wiper and washer switch. If it is not normal condition, replace wiper and wiper switch.

Wiper Switch

Washer Switch

Removal

1.
Remove the steering column shroud lower / upper panel.
(Refer to Body - "Steering Column Shroud Panel")
2.
Disconnect the connector (A).

3.
If necessary of removing the wiper & washer switch (A), release the lock of wiper switch using tool without removing the steering wheel and the clock spring.

4.
Remove the steering wheel.
(Refer to Steering System - "Steering Wheel")
5.
Remove the clock spring.
(Refer to Restraint - "Driver Airbag (DAB) Module and Clock Spring")
6.
Remove the multifunction switch assembly (A) after loosening 2 screws.

Installation

1.
Install the multifunction switch after connecting the connector.
2.
Install the clock spring and steering.
3.
Install the upper and lower shroud.
4.
Install the steering wheel.
    Component Location
    1. Windshield wiper arm & blade 2. Wiper & washer switch 3. Windshield washer hose 4. Windshield wiper motor & linkage 5. Washer motor 6. Wash ...

    Front Wiper Motor Component Location
    1. Cap 2. Nut 3. Wiper arm & blade 4. Rivet 5. Cowl top cover 6. Bolt 7. Wiper motor & linkage assembly ...

    See also:

    Illuminated ENGINE START/STOP button
    Whenever the front door is opened, the ENGINE START/STOP button will illuminate for your convenience. The light will go off after about 30 seconds when the door is closed. When all entrances ...

    License Plate Lamps Repair procedures
    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the license plate lamp assembly (A). 3. Replace the bulb (B) after removing the license plate lamp (A). Installation ...

    Rear Seat Belt Retractor Repair procedures
    Replacement     • When installing the belt, be careful not to damage the retractor. 1. Remove the rear pillar trim. (Refer to Interior Trim - "Rear Pillar ...