Kia Soul: Windshield defrosting and defogging
WARNING - Windshield heating
Do not use the or
position during cooling operation in extremely humid weather. The difference between the temperature of the outside air and that of the windshield could cause the outer surface of the windshield to fog up, causing loss of visibility. In this case, set the mode selection knob or button to the
position and fan speed control knob or button to the lower speed.
- For maximum defrosting, set the temperature control to the extreme right/hot position and the fan speed control to the highest speed.
- If warm air to the floor is desired while defrosting or defogging, set the mode to the floor-defrost position.
- Before driving, clear all snow and ice from the windshield, rear window, outside rear view mirrors, and all side windows.
- Clear all snow and ice from the hood and air inlet in the cowl grille to improve heater and defroster efficiency and to reduce the probability of fogging up inside of the windshield.
Air Conditioning refrigerant label
Each symbols and specification on air conditioning refrigerant label means as
below ;
1. Classification of refrigerant
2. Amount of refrigerant
3. Classification of Compressor lubricant ...
Manual climate control system
To defog inside windshield
1. Select any fan speed except “0” position.
2. Select desired temperature.
3. Select the
or
mode.
4. The outside (fresh) air and air conditioning wil ...
See also:
Power Door Mirror Switch Inspection
1.
Remove the front left door trim.
(Refer to Body - "Front Door Trim")
2.
Remove the power mirror switch co ...
CLOCK SETTINGS
Press the
key
Select [Clock] through
TUNE knob or
key
Select menu through
TUNE
knob
...
Fan speed control
The ignition switch must be in the ON position for fan operation.
The fan speed knob allows you to control the fan speed of the air flow from the
ventilation system. To change the fan speed, turn ...