Kia Soul: Voice Recognition and Phone Contact Tips: - Voice recognition - Features of your vehicleKia Soul: Voice Recognition and Phone Contact Tips:

Kia Soul 2014-2019 PS Owner's Manual / Features of your vehicle / Voice recognition / Voice Recognition and Phone Contact Tips:

The Kia Voice Recognition System may have difficulty understanding some accents or uncommon names. When using Voice Recognition to place a call, speak in a moderate tone, with clear pronunciation To maximize the use of Voice Recognition, consider these guidelines when storing contacts:

  • Do not store single-name entries (e.g., “Bob”, “Mom”, etc.). Instead, always use full names (including first and last names) for these contacts
  • Do not use special characters (e.g., '@', '-', '*', '&', etc.)
  • Do not use abbreviations (i.e., use "Lieutenant" instead of "Lt.") or acronyms (i.e., use "County Finance Department" instead of "C. F. D."; Be sure to say the name exactly as it is entered in the contacts list
  • Do not use acronyms (i.e., use “County Finance Department” instead of “CFD”).
  • If a name is not recognized from the contact list, change it to a more descriptive name (e.g., use “Grandpa Joseph” instead of “Pa Joe”).

Illustration on using voice commands

Starting voice command.

Shortly pressing the key (under 0.8 seconds): key (under 0.8 seconds):

Skipping Prompt Messages

Skipping Prompt Messages

Briefly pressing the key (under 0.8 seconds): key (under 0.8 seconds):

 

 

End voice command.

End voice command.

Briefly pressing the key (under 0.8 seconds): key (under 0.8 seconds):

 

Voice Command List

    Ending voice recognition
    While Voice Recognition is operating Press and hold the key on the steering remote controller While using voice command, pressing any steering wheel control or a different key will end vo ...

    Voice Command List
    Common Commands: These commands can be used in most operations. (However a few commands may not be available during certain operations) FM/AM radio commands: Commands available ...

    See also:

    Installtion
    1. With a putt knife, scrape the old adhesive smooth to a thickness of about 2mm (0.08 in.) on the bonding surface around the entire quarter fixed glass flange. ...

    Repair procedures
    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove engine room under cover. (Refer to Motor System - "Under Cover") 3. Remove the horn (A) after disconnecting the mounting ...

    General Safety Information and Caution
    Safety Precaution     Since electric vehicles contain high voltage batteries, mishandling the high voltage system or vehicle may lead to a serious accident, includi ...