Kia Soul: Under Body - Interior - Body (Interior and Exterior) - Kia Soul 2014-2019 PS Service ManualKia Soul: Under Body

Second generation PS (2014-2019) / Kia Soul 2014-2019 PS Service Manual / Body (Interior and Exterior) / Interior / Under Body

Projected Dimensions

* These dimensions indicated in this figure are actual-measurement dimensions. [ Unit : mm (inch) ]

Actual-Measurement Dimensions

* These dimensions indicated in this figure are actual-measurement dimensions. [ Unit : mm (inch) ]

Front side member tooling hole (Ø25)

Front side member tooling hole (Ø25)

Side cover mounting hole (Ø9)

Side cover mounting hole (Ø9)

Front sub frame mounting bolt

Front sub frame mounting hole (Ø22)

Front sub frame mounting hole (Ø22)
Floor under cover mounting hole (Ø7)

Front side member tooling hole (Ø9)

Center floor side member tooling hole
(Ø25)
Center floor side member extension
tooling hole (Ø7)
Center floor side member extension
tooling hole (Ø7)

Rear floor side member tooling hole
(Ø10)
Rear trailing arm mounting hole (Ø7)
Rear floor cross member extension
tooling hole (Ø7)

Rear floor cross member extension
tooling hole (Ø8)
Rear spring mounting hole (Ø30)
Rear floor side member tooling hole
(Ø25)

Rear floor side member tooling hole
(Ø25)
Rear floor side member tooling hole
(Ø15)
Rear floor side member tooling hole
(Ø13)

    Rear Body
    * These dimensions indicated in this figure are actual-measurement dimensions. [ Unit : mm (inch) ] Tail gate hi ...

    Body Panel Gaps
    * These dimensions indicated in this figure are actual-measurement dimensions. [ Unit : mm (inch) ] ...

    See also:

    Defroster
    CAUTION - Conductors To prevent damage to the conductors bonded to the inside surface of the rear window, never use sharp instruments or window cleaners containing abrasives to clean the window. ...

    Water pump Installation
    1. Install the new gasket and water punp(A). Tightening torque : 9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft) ...

    Front Stabilizer Bar Inspection
    1. Check the bushing for wear and deterioration. 2. Check the front stabilizer bar for deformation. ...