Kia Soul: Troubleshooting - Heating,Ventilation And Air ConditioningKia Soul: Troubleshooting

Kia Soul 2014-2019 PS Service Manual / Heating,Ventilation And Air Conditioning / Troubleshooting

Problem Symptoms Table
Before replacing or repairing air conditioning components, first determine if the malfunction is due to the refrigerant charge, air flow or compressor.
Use the table below to help you find the cause of the problem. The numbers indicate the priority of the likely cause of the problem. Check each part in order. If necessary, replace these parts.
After correcting the malfunction, check the complete system to ensure that performance is satisfactory.
Standard:
Symptom
Suspected Area
No blower operation
1. Blower fuse
2. Blower relay
3. Blower motor
4. Power mosfet
5. Blower speed control switch
6. Wire harness
No air temperature control
1. Engine coolant capacity
2. Heater control assembly
No compressor operation
1. Refrigerant capacity
2. A/C fuse
3. Limiter clutch
4. Compressor
5. A/C pressure transducer
6. A/C switch
7. Evaporator temperature sensor
8. Wire harness
Vented air not cold
1. Refrigerant capacity
2. Refrigerant pressure
3. Drive belt
4. Limiter clutch
5. Compressor
6. A/C pressure transducer
7. Evaporator temperature sensor
8. A/C switch
9. Heater control assembly
10. Wire harness
Insufficient cooling
1. Refrigerant capacity
2. Drive belt
3. Limiter clutch
4. Compressor
5. Condenser
6. Expansion valve
7. Evaporator
8. Refrigerant lines
9. A/C pressure transducer
10. Heater control assembly
No engine idle-up when A/C switch ON
1. Engine ECM
2. Wire harness
No air inlet control
1. Heater control assembly
No mode control
1. Heater control assembly
No cooling fan operation
1. Cooling fan fuse
2. Fan motor
3. Engine ECM
4. Wire harness

    Special Service Tools
    Tool Name / Number Illustration Description Disc & hub assembly bolt remover 09977-3R000 Used for removing / installing disc & hub a ...

    See also:

    Panorama Sunroof Switch Inspection
    1. Disconnect the negative (-) battery terminal. 2. Open the sunglass case cover from the overhead console then remove the ...

    Accumulator Description and Operation
    Description Separates refrigerant in gas/liquid state so that only the refrigerant in gas state can flow into the compressor. ...

    LKA system operation
    To activate/deactivate LKA: With the engine start/stop button in the ON position, LKA turns on automatically. The indicator () in the cluster display will initially illuminate white. If you pre ...