Kia Soul: TPMS Sensor. Diagnosis procedure by using diagnostic device - Tire Pressure Monitoring System - Suspension SystemKia Soul: TPMS Sensor. Diagnosis procedure by using diagnostic device

Kia Soul 2014-2019 PS Service Manual / Suspension System / Tire Pressure Monitoring System / TPMS Sensor. Diagnosis procedure by using diagnostic device

As manual for diagnosis methods by using diagnosis device, the main contents are as follows:
1.
Connect self-diagnosis connector(16pins) located in the lower of driver side crash pad to self-diagnosis device, and then turn the self-diagnosis device after key is ON.
2.
Select the "vehicle model" and "TPMS" on GDS vehicle selection screen, then select OK.
[System Identification (Wireless)]

[Sensor ID Writing (Wireless)]

[VIN input initialization]

[Vehicle name input initialization]

[Sensor Status initialization]

[Register Sensor initialization]

  
Write ID Read ID and be sure to check are the same.
After registering successfully sensor "Sensor Wireless Information" by the execution determines whether the sensor is working properly.
    TPMS Sensor Removal
    1. Remove the tire. (Refer to Tires/Wheels - "Tire") 2. Remove the screw with torx driver (A). ...

    TPMS Receiver Description
    1. Mode (1) Virgin State A. The receiver as a sole part is shipped in this state. ...

    See also:

    Overhead Console Lamp Installation
    1. Install the overhead console lamp after connecting the connector. 2. Install the lens after tightening 2 screws. ...

    Operation
    The oil pump is powered by the engine. ATF passes through the oil filter and gets distributed along the oil channels. The oil becomes highly pressurized as it exits the oil pump and passes ...

    Output Speed Sensor. Specifications
    ▷ Type: Hall effect sensor Operation condition (°C)°F ((-)40 ~ 150)) -40 ~ 302 Air gap(mm)in. (0.85 ~ 1.3) 0.0335 ~ 0.0512 Output voltage ...