Kia Soul: TPMS Receiver Replacement - Tire Pressure Monitoring System - Suspension System - Kia Soul 2014-2019 PS Service ManualKia Soul: TPMS Receiver Replacement

Second generation PS (2014-2019) / Kia Soul 2014-2019 PS Service Manual / Suspension System / Tire Pressure Monitoring System / TPMS Receiver Replacement

  
When the receiver first arrives for replacement:
1)
It will be in Virgin State.
2)
It will not be configured for any specific platform.
3)
It will not have any sensor ID's memorized.
  
It is important to make sure that the correct receiver is used to replace the faulty part i.e. it must be Low Line and not High Line in order to have the correct inflation warning thresholds set.
1.
Disconnect vehicle battery.
2.
Remove the crash pad garnish.
(Refer to BD group - "Crash Pad")
3.
Remove the receiver with bracket.

4.
Install in the reverse order of removal.
5.
Re-connect battery and turn Ignition on.
6.
After replacing the receiver, learn by using self-diagnosis device(GDS).
[Wheel Sensor ID Writing (Wireless) initialization]

[Wheel Sensor ID Writing (Wireless) 1]

[Wheel Sensor ID Writing (Wireless) 2]

    TPMS Receiver Operation
    1. General Function A. Auto-learn takes place only once per Ignition cycle. B. On successful compl ...

    TPMS Receiver. Diagnosis procedure by using diagnostic device
    As manual for diagnosis methods by using diagnosis device, the main contents are as follows: 1. Connect self-diagnosis connector(16pins) located in the lower of driv ...

    See also:

    Manual heating and air conditioning
    The heating and cooling system can be controlled manually by pushing buttons other than the AUTO button. In this case, the system works sequentially according to the order of buttons selected. W ...

    Smart Key Unit Circuit Diagram
    ...

    Crankshaft Position Sensor (CKPS). Troubleshooting
    Waveform This example shows a typical Crankshaft Position Sensor(CkPS) and Camshaft Position Sensor(CMPS) waveform at idle.The PCM controls the injection and ignition timing by using ...