1. |
Install in the reverse order of removal.
|
•
|
Adding Automatic Transaxle Fluid(ATF).
(Refer to Hydraulic System - "Fluid")
|
•
|
Perform Transaxle Control Module(TCM) learning after replacing
the solenoid valve to prevent slow transaxle response, jerky
acceleration and jerky startup.
(Refer to Automatic Transaxle Control System - "Repair
procedures")
|
•
|
Replace the gasket (A) before reinstalling the valve body
cover.

|
|
1.
Remove the under cover.
(Refer to Engine Mechanical System - "Engine Room Under Cover")
2.
Remove the drain plug (A) and dr ...
Underdrive brake control solenoid valve(UD/B) is attached to the valve
body. This variable force solenoid valve directly controls the hydraulic pressure
inside the underdrive brake.
...
See also:
Resetting the sunroof
Whenever the vehicle battery is disconnected or discharged, you must reset your
sunroof system as follows:
1.Turn the ignition switch to the ON position.
2.Close the sunshade and sunroof completel ...
Components and Components Location
Components Location
High Voltage Battery System Assembly
1. BMS ECU2. Main Relay 3. Pre Charge Relay4. Pre Charge Resistor5. Battery Current Sensor6. Safety Plug7. Main Fuse8. Battery Tempera ...
Starter Cleaning
1.
Do not immerse parts in cleaning solvent.
Immersing the yoke assembly and/or armature will damage the insulation
wipe these parts with a cloth only.
...