See also:

High mounted stop light replacement
1. Open the tailgate. 2. Remove the cover. 3. Disconnect the connector by pressing the clip (1). Bulb type 4. Pull out the module from the high mounted stop light assembly by pulling both ...

Manifold Absolute Pressure Sensor (MAPS). Repair procedures
Inspection 1. Connect the GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the MAPS at idle and IG ON. ...

Preset
Press the key ~ Briefly pressing the key (under 0.8 seconds): Plays the frequency saved in the corresponding key. Pressing and holding the key (over 0.8 seconds): Pressing and hol ...