Kia Soul: Thermostat Inspection - Cooling System - Engine Mechanical System - Kia Soul 2014-2019 PS Service ManualKia Soul: Thermostat Inspection

Second generation PS (2014-2019) / Kia Soul 2014-2019 PS Service Manual / Engine Mechanical System / Cooling System / Thermostat Inspection

1.
Immerse the thermostat in water and gradually heat the water.

2.
Check the valve opening temperature.

Valve opening temperature:
82±1.5°C (179.6±2.7°F)
Full opening temperature: 95°C (203°F)

If the valve opening temperature is not as specified, replace the thermostat.
3.
Check the valve lift.

Valve lift : 8mm(0.3in) or more at 95°C (203°F)

If the valve lift is not as specified, replace the thermostat.
    Thermostat Removal
       Disassembly of the thermostat would have an adverse effect, causing a lowering of cooling efficiency. ...

    Thermostat Installation
    1. Place the thermostat in the block. Install the thermostat (B) with the jiggle valve upward. 2. Install the water inlet fitting (A). ...

    See also:

    Repeat
    Press the key Set [ RPT] through the TUNE knob or key to repeat the current song. ❈ Press RPT again to turn off. ...

    Rear camera display (if equipped)
    The rear camera display will activate when the back-up light is ON with the ignition switch ON and the shift lever in the R (Reverse) position. This system is a supplemental system that helps the ...

    Electrical equipment
    The electrical system of your vehicle is designed to perform under all reasonably expected operating conditions. However, before any additional electrical equipment is installed in your vehicle, co ...