Kia Soul: Temperature control - Manual heating and air conditioning - Automatic climate control system - Features of your vehicleKia Soul: Temperature control

Kia Soul 2009-2013 AM Owner's Manual / Features of your vehicle / Automatic climate control system / Manual heating and air conditioning / Temperature control

The temperature will increase to the maximum (HI) by pushing the button ().

The temperature will increase to the maximum (HI) by pushing the button (The temperature will decrease to the minimum (Lo) by pushing the button ().).

The temperature will decrease to the minimum (Lo) by pushing the button (When turning the knob, the temperature will increase or decrease by 0.5°C/1°F.).

When turning the knob, the temperature will increase or decrease by 0.5°C/1°F. When set to the lowest temperature setting, the air conditioning will operate continuously.

Temperature scale conversion

If the battery has been discharged or disconnected, the temperature mode display will reset to Centigrade.

This is normal condition. You can switch the temperature scale as follows;

While pressing the AUTO button, press the OFF button for 3 seconds or more. The temperature scale will change from Centigrade to Fahrenheit, or from Fahrenheit to Centigrade.

    Mode selection
    The mode selection button controls the direction of the air flow through the ventilation system. Refer to the illustration in the “Manual climate control system”. The air flow outlet port is ...

    Air intake control
    This is used to select outside (fresh) air position or recirculated air position. To change the air intake control position, push the control button. Recirculated air position The indicator lig ...

    See also:

    SRS Care
    The SRS is virtually maintenancefree and so there are no parts you can safely service by yourself. If the SRS air bag warning light does not illuminate, or continuously remains on, have your vehic ...

    Fuel Tank Pressure Sensor (FTPS). Repair procedures
    Inspection 1. Connect the GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the FTPS. Specifica ...

    Transaxle Control Module (TCM). Installation
    1. Install in the reverse order of removal.    • ...