Kia Soul: Tail Gate Back Panel Replacement - Tail Gate - Body (Interior and Exterior)Kia Soul: Tail Gate Back Panel Replacement

Kia Soul 2014-2019 PS Service Manual / Body (Interior and Exterior) / Tail Gate / Tail Gate Back Panel Replacement

  
•
Put on gloves to protect your hands.
  
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Take care not to scratch the body surface.
1.
Remove the tail gate trim.
(Refer to Tail Gate - "Tail Gate Trim")
2.
Disconnect the back view camera connector (A).

3.
Loosen the tail gate back panel mounting nuts (A).

4.
Using a screwdriver or remover, remove the tail gate back panel (A).

5.
Install in the reverse order of removal.
  
•
Make sure the connector is plugged in properly.
•
Replace any damaged clips.
    Tail Gate Back Panel Component Location
    1. Tail gate back panel ...

    Tail Gate Lift Replacement
       • Take care to not let the tail gate fall on you as the lifts are removed. Have a help ...

    See also:

    Input Speed Sensor. Inspection
    1. Check signal waveform of Input & output speed sensor using the GDS. Specification: Refer to "Signal Wave Form" section. ...

    Tire sidewall labeling
    This information identifies and describes the fundamental characteristics of the tire and also provides the tire identification number (TIN) for safety standard certification. The TIN can be u ...

    Crankshaft Position Sensor (CKPS). Description and Operation
    Description Crankshaft Position Sensor (CKPS) detects the crankshaft position and is one of the most important sensors of the engine control system. If there is no CKPS signal input, the eng ...