Kia Soul: Tail Gate Assembly Repair procedures - Tail Gate - Body (Interior and Exterior)Kia Soul: Tail Gate Assembly Repair procedures

Kia Soul EV (PS EV) 2015-2020 Service Manual / Body (Interior and Exterior) / Tail Gate / Tail Gate Assembly Repair procedures

Replacement
   
Wear gloves to protect hands from injury.
   
When removing and installing the tail gate, work in a group of two or more.
1.
Remove the tail gate trim.
(Refer to Tail Gate - "Tail Gate Trim")
2.
Disconnect the washer nozzle hose (A).

3.
Disconnect the connectors (A) and tail gate wiring harness (B).
4.
Loosen the ground bolts (C).
5.
After loosening the mounting bolts, remove the tail gate assembly (D).

Tightening torque :
21.6~26.5 N.m (2.2~2.7 kgf.m, 15.9~19.5 lb-ft)

6.
Using a screwdriver, lift the socket clips (A) up slightly on both ends of the tail gate lifter (B).

7.
Install in the reverse order of removal.
   
Make sure that the tail gate locks/unlocks and opens/closes properly.
Adjust the tail gate alignment.
Make sure that the connectors are connected properly.
Replace any damaged clips.
    Tail Gate Assembly Components and Components Location
    Component Location 1. Tail gate assembly ...

    Tail Gate Trim Components and Components Location
    Component Location 1. Tail gate trim ...

    See also:

    Replacement
    1. Disconnect the battery negative cable from the battery and then wait for at least 30 seconds. 2. Turn the steering wheel so that the fro ...

    Rear Wheel Speed Sensor Components and Components Location
    Components 1. Rear wheel speed sensor 2. Extension cable assembly ...

    Checking the coolant level
    Check the condition and connections of all cooling system hoses and heater hoses. Replace any swollen or deteriorated hoses. The coolant level should be filled between F and L marks on the side o ...