Kia Soul: Sunroof - Features of your vehicle - Kia Soul 2009-2013 AM Owner ManualKia Soul: Sunroof

First generation AM (2010Ц2013) / Kia Soul 2009-2013 AM Owner Manual / Features of your vehicle / Sunroof

If your vehicle is equipped with a sunroof, you can slide or tilt your sunroof

If your vehicle is equipped with a sunroof, you can slide or tilt your sunroof with the sunroof control lever located on the overhead console.

The sunroof can only be opened, closed, or tilted when the ignition switch is in the ON position.

In cold and wet climates, the sunroof may not work properly due to freezing conditions.

After the vehicle is washed or in a rainstorm, be sure to wipe off any water that is on the sunroof before operating it.

CAUTION - Sunroof control lever

Do not continue to move the sunroof control lever after the sunroof is fully opened, closed, or tilted. Damage to the motor or system components could occur.

✽ NOTICE

While driving the vehicle, it is recommended that you use the sunroof in the first detent position to reduce possible wind noise.

The sunroof cannot slide when it is in the tilt position nor can it be tilted while in an open or slide position.

Closing the fuel filler lid
1. To install the cap, turn it clockwise until it УclicksФ. This indicates that the cap is securely tightened. 2. Close the fuel filler lid and push it in lightly making sure that it is securely ...

Sliding the sunroof
To open or close the sunroof (manual slide feature), pull or push the sunroof control lever backward or forward to the first detent position. Pulling the control lever downward also closes the su ...

See also:

Crash Pad Lower Panel Component Location
1. Crash pad lower panel ...

Heating and air conditioning
1. Start the engine. 2. Set the mode to the desired position. For improving the effectiveness of heating and cooling; - Heating: - Cooling: 3. Set the temperature control to the desired posi ...

Injector. Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the injector connector. 3. Measure resistance betwee ...