Kia Soul: SRS Control Module (SRSCM). Variant coding
|
■ On-Line type on GDS |
1. |
Ignition "OFF", connect scantool.
|
2. |
Ignition "ON" & Engine "OFF" select vehicle name and airbag system.
|
3. |
Select Variant coding mode.
|
4. |
Follow steps on the screen as below.
|
1) Screen of Retrying the Variant coding after finishing variant
coding
2) Screen of communication failure
|
1) Screen of Retrying the Variant coding after finishing variant
coding
|
SRS Control Module (SRSCM). Installation
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least three
minutes before beginning ...
Front Impact Sensor (FIS). Description
The Front Impact Sensor (FIS) is installed in the Front End Module (FEM).
They are remote sensors that detect acceleration due to a collision at its mounting
location. The primary purpose of ...
See also:
Vehicle break-in process
No special break-in period is needed. By following a few simple precautions for
the first 600 miles (1,000 km) you may add to the performance, economy and life
of your vehicle.
Do not race the ...
Panorama Sunroof Motor Inspection
1.
Close the panorama sunroof glass and blind completely (Full
close position).
2.
Disconnect the negative (-) battery ter ...
Seat Heater (Non-Air Ventilation) Inspection
First Row Seat
1.
Check for continuity and measure the resistance between terminals.
Connector
...