Kia Soul: SRS Control Module (SRSCM). Installation
1. |
Remove the ignition key from the vehicle.
|
2. |
Disconnect the battery negative cable and wait for at least three
minutes before beginning work.
|
3. |
Install the SRSCM with the SRSCM mounting bolts.
|
4. |
Connect the SRSCM harness connector.
|
5. |
Install the rear heating joint duct.
|
6. |
Install the floor console.
(Refer to Body - "Floor console")
|
7. |
Reconnect the battery negative cable.
|
8. |
After installing the SRSCM, confirm proper system operation:
|
SRSCM is sensing the vehicle rollover. SAB, CAB, BPT will be able
to expanse if mechanic moves the SRSCM on vehicle during IGN ON state.
For this reason, turn the IGN OFF surely and then remove the SRSCM from
vehicle.
|
SRS Control Module (SRSCM). Removal
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least three
minutes before beginning ...
SRS Control Module (SRSCM). Variant coding
After replacing the SRSCM with a new one, MUST perform the “Variant Coding”
procedure.
1.
...
See also:
Low aspect ratio tire (if equipped)
Low aspect ratio tires, whose aspect ratio is lower than 50, are provided for
sporty looks.
Because the low aspect ratio tires are optimized for handling and braking, it
may be more uncomfortable ...
Dimensions.Engine
Dimensions
Engine
...
Components and Components Location
Components (1)
1. Front door pull cap2. Front door inside handle cap3. Front door quadrant inner cover 4. Front door trim5. Front door belt inside weatherstrip6. Front door belt outside weathers ...