Kia Soul: Side Impact Sensor (SIS). Removal
Pressure Side Impact Sensor |
|
1. |
Disconnect the battery negative cable, and wait for at least three
minutes before beginning work.
|
2. |
Remove the front door trim.
(Refer to Body - "Front door trim")
|
3. |
Disconnect the pressure side impact sensor connector (A) and remove
the pressure side impact sensor mounting screws (B).
|
Side Impact Sensor
1. |
Disconnect the battery negative cable and wait for at least three
minutes before beginning work.
|
2. |
To remove the semergency fastening device (C), keep on pushing
the lock pin (A) as arrow direction. And then remove the seat belt after
pushing the lock pin (B).
|
3. |
Remove the center pillar lower trim.
(Refer to Body - "Center pillar trim")
|
4. |
Disconnect the side impact sensor connector (A).
|
5. |
Loosen the side impact sensor mounting bolt and then remove the
side impact sensor (B).
|
Side Impact Sensor (SIS). Installation
Pressure Side Impact Sensor
1.
Install the new pressure side impact sensor with the screws (B)
and then connect the pressure side impact sensor connector (A).
...
See also:
Cruise Control Switch Component Location
1. Audio switch (LH)
2. Cruise switch (RH)
3. Bluetooth hands free switch
4. Trip switch
...
Hands Free Switch Inspection
1.
Check for resistance between terminals in each switch position.
[Voice + Bluetooth]
[Voice + Bluetooth]
Switch
...
Loss of the smart key
A maximum of 2 smart keys can be registered to a single vehicle.
If you happen to lose your smart key, you will not be able to start the engine.
You should immediately take the vehicle and remainin ...