Kia Soul: Shift Cable. Removal - Automatic Transaxle Control System - Automatic Transaxle System - Kia Soul 2014-2019 PS Service ManualKia Soul: Shift Cable. Removal

Second generation PS (2014-2019) / Kia Soul 2014-2019 PS Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Shift Cable. Removal

1.
Remove the floor console assembly.
(Refer to Body - "Floor Console")
2.
Remove the rear heating joint duct (A).

3.
Remove the shift cable (A) from the shift lever assembly.

4.
Remove the retainer (A) by loosening the nuts (B).

Tightening torque:
11.8 ~ 14.7 N.m (1.2 ~1.5 kgf.m, 8.7 ~ 10.8 lb-ft)

5.
Remove the air cleaner assembly and air duct.
(Refer to Engine Mechanical System - "Air cleaner")
6.
Battery and battery tray.
(Refer to Engine Electrical System - "Battery")
7.
Remove the shift cable from the transaxle.
(1)
Remove the nut (C) from the manual control lever.

Tightening torque:
9.8 ~ 13.7 N.m (1.0 ~1.4 kgf.m, 7.2 ~ 10.8 lb-ft)

(2)
Remove the cable (B) from the bracket (A).

8.
Remove the shift cable by pulling it toward the interior.
    Shift Cable. Components
    1. Shift lever knob & boots aseembly 2. Shift lever assembly 3. Shift cable assembly 4. Shift cable retainer 5. Shift cable brakcet 6. Manual control lever ...

    Shift Cable. Installation
    1. Install in the reverse order of removal.    • ...

    See also:

    Blower Resistor (Manual) Inspection
    1. Measure the resistance between the terminals. 2. The measured resistance is not within specification, the blower resistor must be replac ...

    Fuel gauge
    The fuel gauge indicates the approximate amount of fuel remaining in the fuel tank. The fuel tank capacity is given in section 8. The fuel gauge is supplemented by a low fuel warning light, whic ...

    Front Wheel Speed Sensor. Components
    1. Front wheel speed sensor 2. Front wheel speed sensor connector ...