Kia Soul: Seat Belt Buckle Switch (BS). Installation - SRSCM - RestraintKia Soul: Seat Belt Buckle Switch (BS). Installation

Kia Soul 2014-2019 PS Service Manual / Restraint / SRSCM / Seat Belt Buckle Switch (BS). Installation

  
Be sure to install the harness wires not to be pinched or interfered with other parts.
1.
Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
2.
Remove the ignition key from the vehicle.
3.
Install the seat belt buckle switch.

Tightening Torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)

4.
Install the front seat assembly.
(Refer to the Body - "Seat")
5.
Reconnect the battery negative cable.
6.
After installing the Seat Belt Buckle Switch, confirm proper system operation:
A.
Turn the ignition switch ON, the SRS indicator should be turned on for about six seconds and then go off.
    Seat Belt Buckle Switch (BS). Removal
    1. Disconnect the battery negative cable, and wait for at least three minutes before beginning work. 2. Remove the front passenger seat as ...

    Occupant Detection System (ODS). Description
    In order to make normal activation of airbag system, SRSCM detects DTC(s) for the Passenger side Body Detection System. If the seat is occupied, Body sensor detects how measuring electrostati ...

    See also:

    Repeat
    Press the key Set [ RPT] through the  TUNE knob or key. Repeats the currently playing song. ❈ Press RPT again to turn repeat off. ...

    Engine oil (Gasoline)
    Checking the engine oil level 1. Be sure the vehicle is on level ground. 2. Start the engine and allow it to reach normal operating temperature. WARNING Radiator hose Be very careful not to t ...

    Rear Door Side Weatherstrip Repair procedures
    Replacement 1. Loosen the rear door checker (B) mounting bolt. Tightening torque : 16.7 ~ 21.6 N.m (1.7 ~ 2.2 kgf.m, 12.3 ~ 15.9 lb-ft) 2. Detach the clips, then remove the rear door sid ...