•
|
Put on gloves to protect your hands.
|
|
•
|
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply protective tape around the related
parts, to prevent damage.
|
•
|
Take care not to scratch the body surface.
|
|
1. |
Using a screwdriver or remover, remove the roof side moulding
(A).
• |
Relplace the roof side moulding to a new one.
|
|
|
2. |
Install in the reverse order of removal.
• |
Replace any damaged clips.
|
|
|
[Panorama Sunroof Type]
•
Put on gloves to protect your hands.
...
•
Put on gloves to protect your hands.
...
See also:
Distributing the sealant
11. Immediately drive approximately 4~6miles (7~10km or, about 10min) to evenly
distribute the sealant in the tire.
Do not exceed a speed of 50 mph (80 km/h). If possible, do not fall below a speed ...
Crankshaft Disassembly
•
Use fender covers to avoid damaging painted surfaces.
•
...
SRS Control Module (SRSCM). Installation
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least three
minutes before beginning ...