Kia Soul: Repair procedures - Floor Carpet - Body (Interior and Exterior)Kia Soul: Repair procedures

Kia Soul EV (PS EV) 2015-2020 Service Manual / Body (Interior and Exterior) / Floor Carpet / Repair procedures

Replacement
   
Put on gloves to protect your hands.
   
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
Take care not to bend or scratch the trim and panels.
1.
Remove both sides of front seat assembly.
(Refer to Front Seat - "Front Seat Assembly")
2.
Remove the rear seat assembly.
(Refer to Rear Seat - "Rear Seat Assembly")
3.
Remove the floor console assembly.
(Refer to Floor Console - "Floor Console Assembly")
4.
Remove both sides of center pillar lower trim.
(Refer to Interior Trim - "Center Pillar Trim")
5.
Remove both sides of cowl side trim.
(Refer to Interior Trim - "Cowl Side Trim")
6.
Remove both sides of luggage side trim.
(Refer to Interior Trim - "Luggage Side Trim")
7.
Remove the safety plug cover (A).
8.
Remove the floor carpet assembly (B).
9.
Remove the rear tunnel pad (B).
10.
Install in the reverse order of removal.
   
Replace any damaged clips.

1. Floor carpet assembly
2. Rear tunnel pad
3. High voltage safety plug cover

    See also:

    Rail Pressure Sensor (RPS). Repair procedures
    Inspection 1. Connect the GDS on the Data Link Connector (DLC). 2. Measure the output voltage of the RPS at idle and various engine speed. ...

    Driving your vehicle
    Be sure the exhaust system does not leak. The exhaust system should be checked whenever the vehicle is raised to change the oil or for any other purpose. If you hear a change in the sound of the ex ...

    SRS components and functions
    The SRS consists of the following components: 1. Driver's front air bag module 2. Passenger's front air bag module* 3. Side air bag modules* 4. Curtain air bag modules* 5. Retractor pre ...