Kia Soul: Repair procedures
Component Replacement after Deployment |
Before doing any SRS repairs, use the GDS to check for DTCs.
Refer to the Diagnostic Trouble Code list for repairing of the related
DTCs. |
– |
SRSCM |
– |
Deployed airbag(s) |
– |
Seat belt pretensioner(s) |
– |
Emergency fastening device |
– |
Front impact sensors |
– |
SRS wiring harnesses |
– |
Inspect the clock spring for heat damage.
If any damage is found, replace the clock spring.
|
– |
SRSCM |
– |
Deployed airbag(s) |
– |
Side impact sensor(s) on the deployed side(s) |
– |
SRS wiring harnesses
|
– |
When the ignition switch is turned ON, the SRS indicator should come on for about 6 seconds before going off. |
General Safety Information and Caution
Precautions
General Precautions
Please read the following precautions carefully before performing the airbag system service.
Carefully observe the instructions described in this manual
as mis ...
Airbag Module
...
See also:
Special Service Tools
Special Service Tools
Tool Name / NumberIllustrationDescriptionBand installer09495-3K000Used to install ear type boot bandPuller09495-33000Used to remove spider assemblyBall joint puller09568-340 ...
Overdrive Clutch Control Solenoid Valve(OD/C_VFS). Description
Overdrive clutch control solenoid valve(OD/C) is attached to the valve
body. This variable force solenoid valve directly controls the hydraulic pressure
inside the overdrive clutch.
...
Driver Airbag (DAB) Module and Clock Spring. Installation
1.
Set the front tires straight-ahead before assembling the steering
wheel.
...