Kia Soul: Removal - Clutch Master Cylinder - Clutch System - Kia Soul 2014-2019 PS Service ManualKia Soul: Removal

Second generation PS (2014-2019) / Kia Soul 2014-2019 PS Service Manual / Clutch System / Clutch Master Cylinder / Removal

1.
Remove the clutch pedal mounting nuts (A).

2.
Separate the push rod (C) after remove the pin (A) and washer (B).

3.
Remove the air cleaner assembly.
G 1.6 GDI (Refer to Engine Mechanical System - "Air Cleaner")
G 2.0 GDI (Refer to Engine Mechanical System - "Air Cleaner")
4.
Remove the battery and battery tray.
G 1.6 GDI (Refer to Engine Electrical System - "Battery")
G 2.0 GDI (Refer to Engine Electrical System - "Battery")
5.
Disconnect the clutch tube (B) and reservoir hose (A) from the clutch master cylinder.
  
Do not spill brake fluid on the vehicle; it may damage the paint if brake fluid does contact the paint, wash it off immediately with water.

    Components
    1. Clutch pedal assembly 2. Ignition lock and clutch switch 3. Master cylinder 4. Clutch tube ...

    Installation
    1. Install in the reverse order of removal. 2. After be equipped, perform bleeding air procedure in clutch release cylinder after pouring t ...

    See also:

    Rear Coil Spring Components
    1. Spring lower pad 2. Spring 3. Spring upper pad ...

    Tie-down hook (for flatbed towing)
    CAUTION - Tie-down hooks Do not use the hooks under the rear of the vehicle for towing purposes. These hooks are designed ONLY for transport tiedown. If the tie-down hooks are used for towing, ...

    Alternator Specification
    Alternator ltem Specification Nominal output 13.5V, 110A Speed in use 1,000 ~ 18,000 rpm Voltage regulator IC Regulator bu ...