Kia Soul: Remote control - Outside rearview mirror - Mirrors - Features of your vehicleKia Soul: Remote control

Kia Soul 2009-2013 AM Owner's Manual / Features of your vehicle / Mirrors / Outside rearview mirror / Remote control

Manual type (if equipped)

Manual type (if equipped)

To adjust an outside mirror, move the control lever.

Electric type (if equipped)

Electric type (if equipped)

The electric remote control mirror switch allows you to adjust the position of the left and right outside rearview mirrors. To adjust the position of either mirror the ignition switch should be in the ACC or ON position. Push the switch (1) to R or L to select the right side mirror or the left side mirror, then press a corresponding point on the mirror adjustment control to position the selected mirror up, down, left or right.

After the adjustment, put the switch into the neutral (center) position to prevent inadvertent adjustment.

CAUTION - Outside mirror

  • The mirrors stop moving when they reach the maximum adjusting angles, but the motor continues to operate while the switch is depressed. Do not depress the switch longer than necessary, the motor may be damaged.
  • Do not attempt to adjust the outside rearview mirror by hand. Doing so may damage the parts.
    Outside rearview mirror
    Be sure to adjust the mirror angles before driving. Your vehicle is equipped with both left-hand and right-hand outside rearview mirrors. The mirrors can be adjusted remotely with the remote switch ...

    Folding the outside rearview mirror
    Manual type (if equipped) To fold the outside rearview mirror, grasp the housing of the mirror and then fold it toward the rear of the vehicle. Electric type (if equipped) To fold the outside ...

    See also:

    Notes on the safe use of the Tire Mobility Kit
    Park your car at the side of the road so that you can work with the TMK away from moving traffic. Place your warning triangle in a prominent place to make passing vehicles aware of your locat ...

    Room Lamp Installation
    Room Lamp 1. Install the room lamp assembly after connecting the lamp connector. 2. Install the lens after assembling the ...

    ICM (Integrated Circuit Module) Relay Box Component
    ...