Kia Soul: Rear Wiper Motor Repair procedures - Rear Wiper/Washer - Body Electrical SystemKia Soul: Rear Wiper Motor Repair procedures

Kia Soul EV (PS EV) 2015-2020 Service Manual / Body Electrical System / Rear Wiper/Washer / Rear Wiper Motor Repair procedures

Inspection
Rear Wiper Motor
1.
Remove the connector from the rear wiper motor.
2.
Connect battery positive (+) and negative (-) cables to terminals 2 and 1 respectively.
3.
Check that the motor operates normally. Replace the motor if it operates abnormally.
No.
Description
1
Battery (+)
2
Parking
3
Ground
4
Signal

Automatic Stop Operation Check
1.
Operate the motor at low speed using the stalk control.
2.
Stop the motor operation anywhere except at the off position by disconnecting terminal 2.
3.
Connect the positive (+) lead from the battery to terminal 2 and the negative (-) lead to terminal 1.
4.
Check that the motor stops running at the off position.

Removal
1.
Detach the rear wiper cap (A).

2.
Remove the rear wiper arm & blade (B) after removing rear wiper HEX nut (A).

3.
Remove the rear wiper grommet (A).

4.
Remove the tailgate trim after opening the tailgate.
(Refer to Body - "Tailgate Trim")
5.
Disconnect the rear wiper motor connector (A) then remove the rear wiper motor (B) after loosening bolts.

Installation
1.
Install the rear wiper motor assembly.

Tightening torque Bolt :
6.9~10.8 Nm (0.7~1.1 kgf.m, 5.1~8.0 lbf.ft)

2.
Install the tailgate trim.
3.
Install the rear wiper arm cap after tighting the nut.

Tightening torque Nut :
3.9~6.9 N.m (0.4~0.7 kgf.m, 2.9~5.1 lbf.ft)

4.
Set the rear wiper blade and to the lowest defogger heat line and tailgate glass.
A : Auto stop position

    Components and Components Location
    Component Location 1. Head cap2. Rear wiper arm nut3. Rear wiper arm & blade4. Grommet5. Rear wiper motor assembly6. Rear wiper motor bolt ...

    Rear Washer Switch Repair procedures
    Inspection 1. Check for continuity between the terminals while operating the wiper and washer switch. If it is not normal condition, replace wiper and wiper switch. Rear Wiper Switch Rear Wa ...

    See also:

    Variable Intake Solenoid (VIS) Valve. Repair procedures
    Inspection 1. Turn the ignition switch OFF. 2. Disconnect the VIS valve connector. 3. Measure resistance betwe ...

    General
    The supplemental restraint system (SRS) is designed to supplement the seat belt to help reduce the risk or severity of injury to the driver and passenger by activating and deploying the drive ...

    Components
    1. Clutch pedal assembly 2. Ignition lock and clutch switch 3. Master cylinder 4. Clutch tube 5. Clutch release cylinder ...