Kia Soul: Rear Wiper Motor Removal - Rear Wiper/Washer - Body Electrical SystemKia Soul: Rear Wiper Motor Removal

Kia Soul 2014-2019 PS Service Manual / Body Electrical System / Rear Wiper/Washer / Rear Wiper Motor Removal

1.
Detach the rear wiper cap (A).

2.
Remove the rear wiper arm & blade (B) after removing rear wiper HEX nut (A).

3.
Remove the rear wiper grommet (A).

4.
Remove the tailgate trim after opening the tailgate.
(Refer to Body - "Tailgate Trim")
5.
Disconnect the rear wiper motor connector (A) then remove the rear wiper motor (B) after loosening bolts.

    Rear Wiper Motor Inspection
    Rear Wiper Motor 1. Remove the connector from the rear wiper motor. 2. Connect battery positive (+) and negative (-) cable ...

    Rear Wiper Motor Installation
    1. Install the rear wiper motor assembly. Tightening torque Bolt : 6.9~10.8 Nm (0.7~1.1 kgf.m, 5.1~8.0 lbf.ft) ...

    See also:

    Steering Column Shroud Panel Repair procedures
    Replacement [Steering column shroud lower panel]     • Put on gloves to protect your hands.     • When prying with a flat- ...

    Drive belts
    Inspect all drive belts for evidence of cuts, cracks, excessive wear or oil saturation and replace if necessary. Drive belts should be checked periodically for proper tension and adjusted as nece ...

    Line Pressure Control Solenoid Valve. Description
    line pressure control solenoid valve is attached to the valve body. This variable force solenoid valve directly controls the hydraulic pressure inside the line pressure. ...