Kia Soul: Rear Washer Switch Inspection
| 1. |
Check for continuity between the terminals while operating
the wiper and washer switch. If it is not normal condition, replace
wiper and wiper switch.
Rear Wiper Switch
Rear Washer Switch
|
Rear Wiper Motor Installation
1.
Install the rear wiper motor assembly.
Tightening torque Bolt :
6.9~10.8 Nm (0.7~1.1 kgf.m, 5.1~8.0 lbf.ft)
...
Rear Washer Motor Inspection
1.
With the washer motor connected to the reservoir tank, fill
the reservoir tank with water.
...
See also:
Front seat adjustment - manual
Forward and backward
To move the seat forward or backward:
1. Pull the seat slide adjustment lever up and hold it.
2. Slide the seat to the position you desire.
3. Release the lever and make s ...
Temperature Control Actuator Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the temperature control actuator connector.
3.
Verify that the temperature control actuator operates to the
cool position when 1 ...
High beam indicator light, High beam assist indicator
High beam indicator light
This indicator light illuminates:
When the headlights are on and in the high beam position
When the turn signal lever is pulled into the Flash-to-Pass position.
H ...