Kia Soul: Rear Seat Belt Retractor Replacement - Rear Seat Belt - Body (Interior and Exterior) - Kia Soul 2014-2018 PS Service ManualKia Soul: Rear Seat Belt Retractor Replacement

Second generation PS (2014-2018) / Kia Soul 2014-2018 PS Service Manual / Body (Interior and Exterior) / Rear Seat Belt / Rear Seat Belt Retractor Replacement

  
Х
When installing the belt, make sure not to damage the retractor.
1.
Remove the rear pillar trim.
(Refer to Interior Trim - "Rear Pillar Trim")
2.
Loosen the rear seat belt upper anchor (A) mounting bolt.
3.
After loosening the mounting bolt, then remove the rear seat belt retractor (B).

Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.8 ~ 39.8 lb-ft)

4.
Install in the reverse order of removal.
  
Х
Make sure the connector is plugged in properly.
Х
Replace any damaged clips.
    Rear Seat Belt Retractor Component Location
    1. Rear seat belt retractor ...

    Rear Center Seat Belt Retractor Component Location
    1. Rear center seat belt retractor ...

    See also:

    Component Location
    1. Fender assembly ...

    Auto Light Sensor Inspection
    In the state of IGN1 ON, when the multi function switch module detects auto light switch on, tail lamp relay output and head lamp low relay output are controlled according to auto light se ...

    Crankshaft Position Sensor (CKPS). Description and Operation
    Description Crankshaft Position Sensor (CKPS) detects the crankshaft position and is one of the most important sensors of the engine control system. If there is no CKPS signal input, the eng ...