Kia Soul: Rear Door Window Glass Repair procedures - Rear Door - Body (Interior and Exterior)Kia Soul: Rear Door Window Glass Repair procedures

Kia Soul EV (PS EV) 2015-2020 Service Manual / Body (Interior and Exterior) / Rear Door / Rear Door Window Glass Repair procedures

Replacement
1.
Remove the rear door trim.
(Refer to Rear Door - "Rear Door Trim")
2.
Remove the rear door belt inside weatherstrip (A).

3.
Hold down the power window glass switch to pull down the rear door window glass to the maximum level.
4.
After loosening the mounting screws, remove the rear door belt outside weatherstrip (A).

5.
After loosening the mounting screws, remove the rear door delta garnish (A).

6.
Completely loosen the rear door channel mounting bolt and loosen the nuts as much as possible until they are just enough to hold the rear door panel.
7.
Slightly push the rear door channel in the direction of the arrow in the illustration below.

8.
Remove the rear door window glass mounting hole plug (A).

   
Be careful not to drop the glass and/or scratch the glass surface.
   
Use the door switch to align the mounting hole/bolt with the hole in the door.
If unable to operate the window motor, remove the motor and align the hole by hand.
9.
Carefully adjust the rear door window glass (A) until you can see the bolt, then loosen them. Separate the glass from the glass run and carefully pull the glass out through the window slot.

Tightening torque :
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

10.
Install in the reverse order of removal.
   
Roll the glass up and down to see if it moves freely without binding.
Adjust glass position as needed.
Make sure that the door locks and opens properly.
Replace any damaged clips.
    Rear Door Window Glass Components and Components Location
    Component Location 1. Rear door window glass ...

    Rear Door Module Components and Components Location
    Component Location 1. Rear door module ...

    See also:

    On inclines
    During uphill or downhill driving, Smart Cruise Control system may not detect a moving vehicle in your lane, and cause your vehicle to accelerate to the set speed. Also, the vehicle speed w ...

    Air Ventilation Seat Control Unit Installation
    Cushion Blower 1. Install the cushion blower. 2. Install the front seat assembly. Back Blower ...

    Vehicle stability management (VSM)
    This system provides further enhancements to vehicle stability and steering responses when a vehicle is driving on a slippery road or a vehicle detected changes in coefficient of friction between ...