Kia Soul: Rear Door Module Repair procedures - Rear Door - Body (Interior and Exterior)Kia Soul: Rear Door Module Repair procedures

Kia Soul EV (PS EV) 2015-2020 Service Manual / Body (Interior and Exterior) / Rear Door / Rear Door Module Repair procedures

Replacement
1.
Remove the rear door window glass.
(Refer to Rear Door - "Rear Door Window Glass")
2.
Remove the rear door outside handle.
(Refer to Rear Door - "Rear Door Outside Handle")
3.
After loosening the mounting bolt and nuts, remove the rear door channel (A).

Tightening torque :
Bolt : 6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft)
Nut : 3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)

4.
Disconnect the rear door main connector (A).

5.
Loosen the rear door outside handle base mounting bolt (A).

6.
Loosen the rear door latch (A) mounting screws.
7.
After loosening the mounting bolts, remove the rear door module (B).

Tightening torque :
Bolt : 7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)
Screw : 7.8 ~ 10.8 N.m (0.8 ~ 1.1 kgf.m, 5.8 ~ 8.0 lb-ft)

8.
Remove the rear door main connector mounting clips (A).

9.
Remove the rear door module wiring harness mounting clips (A).

10.
Disconnect the rear door latch connector (A) and then remove the mounting clip (B).

11.
Disconnect the connectors and rear door module wiring harness (A).

12.
Remove the rear door latch assembly.
(Refer to Rear Door - "Rear Door Latch")
13.
Remove the rear speaker.
(Refer to Body Electrical System - "Speakers")
14.
Remove the rear power window motor.
(Refer to Body Electrical System - "Power Window Motor")
15.
Install in the reverse order of removal.
   
Apply sufficient grease on all rolling friction parts and springs.
Make sure that connectors are connected properly and each rod is connected securely.
Make sure that the door locks/unlocks and opens/closes properly.
    Rear Door Module Components and Components Location
    Component Location 1. Rear door module ...

    Rear Door Outside Handle Components and Components Location
    Component Location 1. Rear door outside handle ...

    See also:

    Passenger Airbag (PAB) Module. Removal
    1. Disconnect the battery negative cable and wait for at least thirty seconds before beginning work. 2. Remove the glove box housing. ...

    With central door lock switch
    Operate by pressing the central door lock switch. When pressing the right portion (1) for driver side of the switch, all vehicle doors will lock. When pressing the left portion (2) for driv ...

    Specifications
    Specifications ItemsSpecificationsRated voltageDC 12VOperating temperature range-30°C ~ +80°C (-22 ~ +176°F)Rated loadDimmer & passing switchHigh : 1A (Relay load)Low : 1A (Relay load)Pass ...