Kia Soul: Rear combination light bulb replacement
Type A
Type B
(1) Tail light and side marker
(2) Rear turn signal light
(3) Back-up light
(4) Stop and tail light
(5) Tail light
(6) Stop and tail (LED)
1. Open the tailgate.
2. Loosen the light assembly retaining screws with a philips head screwdriver.
3. Remove the rear combination light assembly from the body of the vehicle.
Tail light and side marker, Turn signal light and Stop and tail light
4. Remove the socket from the assembly by turning the socket counterclockwise
until the tabs on the socket align with the slots on the assembly.
5. Remove the bulb from the socket by pressing it in and rotating it counterclockwise
until the tabs on the bulb align with the slots in the socket.
6. Insert a new bulb by inserting it into the socket and rotating it until it locks
into place.
7. Install the socket in the assembly by aligning the tabs on the socket with the
slots in the assembly and turning the socket clockwise.
8. Reinstall the light assembly to the body of the vehicle.
Back-up light and Tail light
Follow the steps 1 to 3 from the previous page.
4.Remove the socket from the assembly by turning the socket counterclockwise
until the tabs on the socket align with the slots on the assembly.
5.Pull the bulb out of the socket.
6.Insert a new bulb into the socket.
7.Install the socket into the assembly by aligning the tabs on the socket with the
slots on the assembly and turning the socket clockwise.
8.Reinstall the light assembly to the body of the vehicle.
Side repeater light bulb Type B replacement
If the light bulb is not operating, have the vehicle checked by an authorized
Kia dealer. ...
High mounted stop light replacement
1. Open the tailgate.
2. Remove the cover.
3. Disconnect the connector by pressing the clip (1).
Bulb type
4. Pull out the module from the high mounted stop light assembly by pulling both
...
See also:
Before Using the Bluetooth® Wireless Technology Handsfree
What is Bluetooth® ?
Bluetooth® refers to a short-distance wireless networking technology which
uses a 2.4GHz ~ 2.48GHz frequency to connect various devices within a certain
distance.
Su ...
Output Speed Sensor. Removal
1.
Remove the valve body assembly.
(Refer to Hydraulic System - "Valve Body")
2.
Disconnect the input & output speed senso ...
High Voltage Battery Heater Repair procedures
Inspection
When removing the battery pack assembly to inspect the
battery system, it can be connected to vehicle by using the SST
0K918-E4100, 0K375-E4100, 0K375-E4 ...