Kia Soul: Rear Combination Lamp - Lighting System - Body Electrical System - Kia Soul 2014-2019 PS Service ManualKia Soul: Rear Combination Lamp

Second generation PS (2014-2019) / Kia Soul 2014-2019 PS Service Manual / Body Electrical System / Lighting System / Rear Combination Lamp

Removal

Rear Combination Lamp
1.
Disconnect the negative (-) battery terminal.
2.
Remove the rear combination lamp (A) after loosening the mounting screws.

3.
Disconnect the rear combination lamp connector (A).

Turn Signal Lamp Bulb
1.
Disconnect the negative (-) battery terminal.
2.
Remove the rear combination lamp assembly.
3.
Remove the turn signal lamp socket (A) by turning the socket conuterclockwise.

4.
Remove the turn signal lamp bulb (A).

Back Up Lamp Bulb
1.
Disconnect the negative (-) battery terminal.
2.
Remove the rear combination lamp assembly.
3.
Remove the back up lamp socket (A) by turning the socket conuterclockwise.

4.
Remove the back up lamp bulb (A).

Tail & Side Marker Lamp Bulb
1.
Disconnect the negative (-) battery terminal.
2.
Remove the rear combination lamp assembly.
3.
Remove the tail & side marker socket (A) by turning the socket conuterclockwise.
[Top]

[Middle]

[Bottom]

4.
Remove the tail & side marker lamp bulb (A).
[Top]

[Middle]

[Bottom]

Installation

1.
Install the rear combination lamp assembly.
2.
Connect the negative (-) battery terminal.
    Luggage Lamp
    Removal 1. Disconnect the negative (-) battery terminal. 2. Using a screwdriver or remover, remove the luggage lamp (A). ...

    See also:

    Auto stop
    Type A Type B To stop the engine in idle stop mode Stop the vehicle completely by pressing the brake pedal. You must reach a speed of at least 5 mph (8 km/h) since last idle stop. The engine ...

    Description
    The starting system includes the battery, starter, solenoid switch, ignition switch, inhibitor switch (A/T), clutch pedal switch (M/T), ignition lock switch, connection wires and the battery ...

    Parking Brake Lever. Removal
       The parking brake cables must not be bent or distorted. This will lead to stiff operation and premature failure. ...