•
|
Put on gloves to protect your hands. |
|
•
|
When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply protective tape around the related parts, to
prevent damage. |
•
|
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface. |
•
|
Take care not to bend or scratch the trim and panels. |
|
1. |
After loosening the mounting screws, remove the rear combination lamp (A). 
|
2. |
Disconnect the rear combination lamp connector (A). 
|
3. |
Loosen the rear bumper upper mounting clip (A). 
|
4. |
Loosen the bolts and nuts, and then remove the rear under cover (A). 
|
5. |
Loosen the mounting bolts (A). 
|
6. |
Disconnect the rear bumper main connector (A). 
|
7. |
After loosening the rear bumper side''s mounting screws and clip, separate the sides.
•
|
Slightly lift up the side of the rear bumper and pull in the direction of the arrow to remove. |
|
•
|
When pulling out the front bumper, be careful not to damage the side part of the rear bumper. |
|


|
8. |
Remove the rear bumper cover (A). 
|
9. |
Install in the reverse order of removal.
•
|
Make sure that the connectors are plugged in properly. |
•
|
Replace any damaged clips. |
|
|
Component Location
1. Rear bumper cover
...
Component Location
1. Rear bumper beam assembly
...