Kia Soul: Rear Bumper Beam Assembly Repair procedures - Rear Bumper - Body (Interior and Exterior)Kia Soul: Rear Bumper Beam Assembly Repair procedures

Kia Soul EV (PS EV) 2015-2020 Service Manual / Body (Interior and Exterior) / Rear Bumper / Rear Bumper Beam Assembly Repair procedures

Replacement
   
•
Put on gloves to protect your hands.
   
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Remove the rear bumper cover.
(Refer to Rear Bumper - "Rear Bumper Cover")
2.
Disconnect the bumper antenna connector (A) and license lamp connector (B).
3.
Remove the joint connector mounting clip (C).

4.
Remove the rear bumper wiring harness mounting clips (A).
5.
Remove the mounting clips (B) and the rear bumper beam assembly (C), and then loosen the clips.

6.
Install in the reverse order of removal.
   
•
Make sure that the connectors are plugged in properly.
•
Replace any damaged clips.
    Rear Bumper Beam Assembly Components and Components Location
    Component Location 1. Rear bumper beam assembly ...

    Rear Door
    ...

    See also:

    Using Voice Recognition
    Starting Voice Recognition Shortly press the key on the steering wheel. Say a command If prompt feedback is in [ON], then the system will say “Please say a command after the beep (BEEP)â ...

    Fuel Pressure Control Valve. Description and Operation
    Description Fuel Pressure Regulator Valve is installed on the high pressure fuel pump and controls fuel flow flowing into the injectors in accordance with the ECM signal calculated based on ...

    Windshield Wiper-Washer Switch
    Inspection Check for continuity between the terminals while operating the wiper and washer switch. If it is not normal condition, replace wiper and wiper switch. Wiper Switch ...