Kia Soul: Power Window Motor Repair procedures - Power Windows - Body Electrical SystemKia Soul: Power Window Motor Repair procedures

Kia Soul EV (PS EV) 2015-2020 Service Manual / Body Electrical System / Power Windows / Power Window Motor Repair procedures

Inspection
Front Power Window Motor
1.
Disconnect the negative (-) battery terminal.
2.
Remove the front door trim.
(Refer to Body - "Front Door Trim")
3.
Disconnect the connector (A) from the motor.
(A : Safety, B : Standard)

4.
Connect the motor terminals directly to battery voltage (12V) and check that the motor operates smoothly. Next, reverse the polarity and check that the motor operates smoothly in the reverse direction. If the operation is abnormal, replace the motor.
[General Window Motor]

5.
Connect the terminals No. 2 and No. 3 to battery voltage (12V) and check that the motor operates smoothly when connected to the following terminals.
[Safety Window Motor]

Rear Power Window Motor
1.
Disconnect the negative (-) battery terminal.
2.
Remove the rear door trim.
(Refer to Body - "Rear Door Trim")
3.
Disconnect the connector (A) from the motor.

4.
Connect the motor terminals directly to battery voltage (12V) and check that the motor operates smoothly. Next, reverse the polarity and check that the motor operates smoothly in the reverse direction. If the operation is abnormal, replace the motor.

    Power Window Switch Components and Components Location
    Components Driver Power Window Switch Assist Power Window Switch Rear Power Window Switch ...

    See also:

    TPMS Sensor Removal
    1. Remove the tire. (Refer to Tires/Wheels - "Tire") 2. Remove the screw with torx driver (A). ...

    Position lamp/DRL/Front turn signal lamp bulb replacement (Type A, B)
    1. Open the hood. 2. Remove the bulb socket-connector by turning it counterclockwise. 3. Remove the bulb from the lamp assembly. 4. Install a new bulb. 5. Connect the bulb socket-connector. Hea ...

    Manual climate control system
    1. Turn the ignition switch to the ON position. 2. Turn the mode selection knob to the defrost position (). 3. Push the air intake control button at least 5 times within 3 seconds. The indicator ...