Kia Soul: Parking Brake Lever. Removal - Parking Brake System - Brake SystemKia Soul: Parking Brake Lever. Removal

Kia Soul 2014-2019 PS Service Manual / Brake System / Parking Brake System / Parking Brake Lever. Removal

  
The parking brake cables must not be bent or distorted. This will lead to stiff operation and premature failure.
1.
Release the parking brake lever and parking brake cable is loose.
2.
Remove the floor console assembly.
(Refer to Body - "Floor console")
3.
Disconnect the connector (A) of parking brake switch.

4.
Loosen the adjusting nut (A) and the parking brake cables (B).

  
Parking brake lever in the car must be in fully loosened position.
5.
Remove the parking brake lever assembly (A) after removing the bolts.

    Components
    1. Parking brake lever 2. Parking brake cable 3. Equalizer assembly ...

    Parking Brake Lever. Installation
    1. Install the parking brake lever assembly (A). Tightening torque : 19.6 ~ 29.4 N.m (2.0 ~ 3.0 kgf.m, 14.5 ~ 21.7 lb-ft) ...

    See also:

    Antenna Coil Installation
    1. Install the coil antenna and connect the 6P connector. 2. Install the crash pad lower panel. 3. ...

    Front fog light (if equipped)
    Fog lights are used to provide improved visibility when visibility is poor due to fog, rain or snow, etc. The fog lights will turn on when the fog light switch (1) is turned to the on position ...

    Cowl Side Trim Component Location
    1. Cowl side trim ...