Kia Soul: Panorama Sunroof Motor Inspection - Panorama Sunroof - Body Electrical System - Kia Soul 2014-2019 PS Service ManualKia Soul: Panorama Sunroof Motor Inspection

Second generation PS (2014-2019) / Kia Soul 2014-2019 PS Service Manual / Body Electrical System / Panorama Sunroof / Panorama Sunroof Motor Inspection

1.
Close the panorama sunroof glass and blind completely (Full close position).
2.
Disconnect the negative (-) battery terminal.
3.
Remove the roof trim assembly.
(Refer to Body - "Roof Trim")
4.
Remove the panorama sunroof glass motor (A) after loosening the screws and disconnecting the connector.

5.
Check the wiring connector of the panorama sunroof glass motor as below table.
Terminal
Test condition
Test : Desired result
3 - GND
IG2 ON
Check for voltage to ground :
There should be battery voltage
1 - GND
Under all conditions
Check for continuity to ground :
There should be continuity.
6 - GND
Under all conditions
Check for voltage to ground :
There should be battery voltage.

6.
Remove the blind motor (A) after loosening the screws and disconnecting the connector.

7.
Check the wiring connector of the blind motor as below table.
Terminal
Test condition
Test : Desired result
1 - GND
Under all conditions
Check for continuity to ground :
There should be continuity.
6 - GND
Under all conditions
Check for voltage to ground :
There should be battery voltage.

8.
Connect the panorama sunroof glass and blind motor and each connectors.
  
Be careful not to reinstall the motors on the panorama sunroof.
9.
Connect the negative (-) battery terminal.
10.
Start the vehicle engine.
11.
Check the motor's operation by pressing the panorama sunroof switch.
Terminal
Operation Test
Glass open
switch
Both the glass and blind motors operate
Glass close
switch
Both the glass motors operate
Glass tilt up
switch
Both the glass and blind motors operate
Blind open
switch
The blind motor operates
Blind close
switch
The blind motor operates

12.
Pless the auto close switch after checking the motor's operation.
13.
Install the panorama sunroof glass motor and blind motor. And then perform the resetting procedure of the panorama sunroof.
  
Use only the auto close switch.
    Panorama Sunroof Switch Inspection
    1. Disconnect the negative (-) battery terminal. 2. Open the sunglass case cover from the overhead console then remove the ...

    Panorama Sunroof Motor Replacement
    Resetting The Panoramaroof Whenever the vehicle battery is disconnected or discharged, or you use the emergency handle to operate the panoramaroof, you have to reset your panoramaroo ...

    See also:

    Parking Brake Lever. Removal
       The parking brake cables must not be bent or distorted. This will lead to stiff operation and premature failure. ...

    Drive Belt Tensioner Removal and Installation
    1. Remove the drive belt. (Refer to Timing System - "Dreve Belt") 2. Remove the alternator. (Refer to Engine Electrica ...

    Inspection
    Clutch cover assembly 1. Check the diaphragm spring end for wear and uneven height. 2. Check the pressure plate surface for we ...