Kia Soul: Occupant Detecting Sensor (ODS) Repair procedures - SRSCM - RestraintKia Soul: Occupant Detecting Sensor (ODS) Repair procedures

Kia Soul EV (PS EV) 2015-2020 Service Manual / Restraint / SRSCM / Occupant Detecting Sensor (ODS) Repair procedures

Removal
1.
Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
2.
Remove the front passenger seat assembly. (Refer to the Body group- Seat)
3.
Remove the seat cushion assembly. (Refer to the Body group- Seat)
Installation
1.
Install the ODS equipped seat cushion assembly. (Refer to the Body group- Seat)
2.
Install the front passenger seat assembly.
(Refer to the Body group - seat)
3.
Reconnect the battery negative cable.
4.
After installing the ODS, confirm proper system operation :
Turn the ignition switch ON the SRS indicator should be turned on for about six seconds and then go off.
Telltale lamp will turn on for 4 seconds and be turned off for 3 seconds. After the 7 seconds, it shall remain off if the ODS does not require suppression and the passenger airbag is enabled.
    Schematic Diagrams
    Circuit Diagram (1) Circuit Diagram (2) Circuit Diagram (3) SRSCM Connector Terminal Harness Connector Pin No.Function (Connector A)Pin No.Function (Connector B)1--1--2--2--3--3--4- -4-- ...

    See also:

    Rear Hub - Carrier Components
    1. Rear dust cover 2. Rear wheel hub assembly 3. Rear brake disc ...

    Components
    [M/T] 1. Floor console assembly 2. Hole cover 3. Parking brake cover 4. Ash tray 5. Console side cover [LH] 6. Console side cover [RH] 7. Console center ...

    Description and Operation
    Heat Pump Configuration and Operation Heat pump is configured to circulate refrigerant flow for cooling/heating function. This process minimizes battery consumption by the heater resulting in enha ...