Kia Soul: Map lamp - Interior light - Features of your vehicleKia Soul: Map lamp

Kia Soul 2014-2019 PS Owner's Manual / Features of your vehicle / Interior light / Map lamp

Press the lens (1) or button (1) to turn the map lamp on or off

Press the lens (1) or button (1) to turn the map lamp on or off

ROOM (2) :

- The map lamp and room lamp stays on at all times.
- To turn off the ROOM mode, press the ROOM button (2) once again (not pressed.)

DOOR (3) :

- The map lamp and room lamp comes on when a door is opened. The lamps go out after approximately 30 seconds.
- The map lamp and room lamp comes on for approximately 30 seconds when doors are unlocked with a transmitter or smart key as long as the doors are not opened.
- The map lamp and room lamp will stay on for approximately 20 minutes if a door is opened with the ignition switch in the ACC or LOCK/OFF position.
- The map lamp and room lamp will stay on continuously if the door is opened with the ignition switch in the ON position.
- The map lamp and room lamp will go out immediately if the ignition switch is changed to the ON position or all doors are locked.
- To turn off the DOOR mode, press the DOOR button (3) once again (not pressed).

✽ NOTICE

  • When the lamp is turned on by pressing the lens (1), the lamp does not turn off even if the DOOR mode or ROOM mode is not selected (not pressed).
  • If the ROOM button and DOOR button are pressed at the same time, the map lamp and room lamp will stay on at all times (ROOM mode will be selected).
    Interior lamp AUTO cut
    When all entrances are closed, if you lock the vehicle by using the transmitter or the smart key, all interior lamp will be off after a few seconds. If you do not operate anything in the ...

    Room lamp
    Press the button to turn the light on or off. If the front map lamp turns on by the front map lamp switch, the room lamp will turn on. ...

    See also:

    ENGINE START/STOP button position
    OFF With manual transaxle To turn off the engine (START/RUN position) or vehicle power (ON position), stop the vehicle then press the engine start/stop button. With automatic transaxle To tu ...

    Receiver-Drier Replacement
    1. Remove the condenser. 2. Remove the cap (B) on the bottom of the condenser with a L wrench (A). Tightening to ...

    Side Airbag (SAB) Module. Components
    ...