Kia Soul: Installation - Ignition Switch Assembly - Body Electrical SystemKia Soul: Installation

Kia Soul 2014-2019 PS Service Manual / Body Electrical System / Ignition Switch Assembly / Installation

1.
Install the key lock cylinder.
2.
Install the key warning and immobilizer connector.
3.
Install the ignition switch assembly.

Tightening torque:
7 ~ 13 N.m (0.7 ~ 1.3, kgf.m, 5.0 ~ 9.6 lb-ft)

  
After assembling the ignition switch assembly, the head of bolt must be broken.
4.
Install the steering column shrouds and crash pad lower panel.
    Removal
    1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body - "Crash Pad ...

    See also:

    Operation in foreign countries
    If you are going to drive your vehicle in another country, be sure to: Observe all regulations regarding registration and insurance. Determine that acceptable fuel is available. ...

    Certification label
    The certification label is located on the driver's door sill at the center pillar. This label shows the maximum allowable weight of the fully loaded vehicle. This is called the GVWR (Gross ...

    ENGINE START/STOP button position
    OFF Not illuminated • With manual transaxle To turn off the engine, stop the vehicle then press the ENGINE START/STOP button with the ENGINE START/STOP button ON. • With automatic transaxl ...