Kia Soul: High Voltage Shut-off Procedures - RestraintKia Soul: High Voltage Shut-off Procedures

Kia Soul EV (PS EV) 2015-2020 Service Manual / Restraint / High Voltage Shut-off Procedures

High Voltage Shut-off Procedure
   
Be sure to read and follow the “General Safety Information and Caution” before doing any work related with the high voltage system. Failure to follow the safety instructions may result in serious electrical injuries.
   
High voltage components : High Voltage Battery, Power Relay Assembly (PRA), Quick Charge Relay Assembly (QRA), Motor, Power Cable, BMS ECU, Inverter, LDC, On-Board Charger (OBC), Main Relay, Pre-charge Relay, Pre-charge resistor, Battery Current Sensor, Safety Plug, Main Fuse, Battery Temperature Sensor, Busbar, Charge Port, A/C Compressor, Electric Power Control Unit (EPCU), High Voltage Heater, High Voltage Heater Relay etc.
1.
Turn the ignition switch OFF and disconnect the negative (-) terminal of the auxiliary battery.
2.
Remove the cover (A) on the floor carpet of the rear seat.

3.
After loosening the nut, remove the safety plug service cover (A).

Safety plug service cover mounting nut : 7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

4.
Remove the safety plug (A).

   
Remove the safety plug in the follwing order.

5.
Wait at least 5 minutes or until the capacitor in the high voltage system is fully discharged.
6.
Measure the voltage between the inverter terminals to check that the capacitor in the inverter is discharged completely
(1)
Lift the vehicle.
(2)
Remove the high voltage battery lower cover (A) by loosening the bolt.

(3)
Remove the high voltage cable (A).

(4)
Measure the voltage between the inverter terminals.

Less than 30V : High voltage circuit properly shut
More than 30V : Faulty on high voltage circuit

   
If measured voltage is over 30V even though the safety plug has been removed properly, there may be a serious problem in the high voltage circuit. In this case, check DTC and never touch on the high voltage system.
    General Safety Information and Caution
    Safety Precaution     Since electric vehicles contain high voltage batteries, mishandling the high voltage system or vehicle may lead to a serious accident, includi ...

    General Information
    General The supplemental restraint system (SRS) is designed to supplement the seat belt to help reduce the risk or severity of injury to the driver and passenger by activating and deploying the ...

    See also:

    Antenna Coil Installation
    1. Install the coil antenna and connect the 6P connector. 2. Install the crash pad lower panel. 3. ...

    Sunvisor
    Use the sunvisor to shield direct light through the front or side windows. To use the sunvisor, pull it downward. To use the sunvisor for the side window, pull it downward, unsnap it from the br ...

    Brake lines, hoses and connections Inspection
    Visually check for proper installation, chafing, cracks, deterioration and any leakage Replace any deteriorated or damaged parts immediately. ...