Kia Soul: High mounted stop light replacement
1. Open the tailgate.
2. Remove the cover.
3. Disconnect the connector by pressing the clip (1).
Bulb type
4. Pull out the module from the high mounted stop light assembly by pulling both
clips.
5. Replace the bulbs by pulling it out.
6. Reinstall in the reverse order.
LED type
4.Loosen the retaining bolts.
5.Replace the LED with new one.
6.Reinstall in the reverse order.
If your vehicle is equipped with LED type high mounted stop lights, your stop, tail and side marker lights must be replaced by an authorized Kia dealer.
Rear combination light bulb replacement
Type A
Type B
(1) Tail light and side marker
(2) Rear turn signal light
(3) Back-up light
(4) Stop and tail light
(5) Tail light
(6) Stop and tail (LED)
1. Open the tailgate.
2. Loosen ...
License plate light bulb replacement
1. Remove the lens by pressing the tabs.
2. Remove the socket from the lens.
3. Remove the bulb by turning it counter clockwise.
4. Install a new bulb in the socket and install the socket to the ...
See also:
Torque Converter Control Solenoid Valve (T/CON_VFS). Specifications
Direct control VFS[T/CON]
▷ Control type : Normal low type
Control Pressure kpa (kgf/cm², psi)
9.81 ~ 500.14 (0.1 ~ 5.1, 1.42 ~ 72.54)
Current value(mA)
...
Rail Pressure Sensor (RPS). Repair procedures
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the RPS at idle and various engine
speed. ...
Component Location
1. Windshield deicer relay (Built-in ICM relay box)
2. Windshield deicer switch (FATC type)
3. Windshield deicer switch (Manual type)
4. Windshield deiecr
5. ...