Kia Soul: High Mounted Stop Lamp Repair procedures - Lighting System - Body Electrical SystemKia Soul: High Mounted Stop Lamp Repair procedures

Kia Soul EV (PS EV) 2015-2020 Service Manual / Body Electrical System / Lighting System / High Mounted Stop Lamp Repair procedures

Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the high mounted stop lamp trim (A).

3.
Detach the high mounted stop lamp (A) from the tailgate after loosening the mounting bolts.

4.
Remove the high mounted stop lamp (C) after disconnecting the connector (B) and hose (A).

Installation
1.
Install the high mounted stop lamp.
2.
Install the high mounted stop lamp trim.
3.
Connect the negative (-) battery terminal.
    License Plate Lamps Repair procedures
    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the license plate lamp assembly (A). 3. Replace the bulb (B) after removing the license plate lamp (A). Installation ...

    Luggage Lamp Repair procedures
    Removal 1. Disconnect the negative (-) battery terminal. 2. Using a screwdriver or remover, remove the luggage lamp (A). 3. Remove the luggage lamp (A) after disconnecting the connector (B ...

    See also:

    On-board Refueling Vapor Recovery (ORVR) valve Removal
    1. Turn the ignition switch OFF, and then remove battery (-) cable. 2. Remove the fuel pump. (Refer to Fuel System - "Fuel Pump&qu ...

    Output Speed Sensor. Signal Waveform
    Fig 1) Input/Output speed sensor at low speed Fig 2) Input/Output speed sensor at high speed ...

    Forward and rearward
    To move the seat forward or rearward: 1. Pull the seat slide adjustment lever up and hold it. 2. Slide the seat to the position you desire. 3. Release the lever and make sure the seat is locked i ...