Kia Soul: Heater Unit Components and Components Location - Heater - Heating,Ventilation, Air ConditioningKia Soul: Heater Unit Components and Components Location

Kia Soul EV (PS EV) 2015-2020 Service Manual / Heating,Ventilation, Air Conditioning / Heater / Heater Unit Components and Components Location

Component Location

1. Heater unit




Components
[LH]

1. Floor shower duct assembly [LH]
2. Duct sensor
3. Interior condenser cover
4. Heater core cover
5. Temp door arm
6. Temp door lever
7. Temp actuator motor assembly
8. Floor door lever
9. Mode actuator motor assembly [LH]
10. Mode cam
11. Motor & wheel assembly



12. Ventilation guide
13. Heater case [LH]
14. Duct sensor
15. Joint flange cap
16. Interior condenser
17. Evaporator core lower insulation
18. Floor door assembly
19. Vent door assembly [LH]
20. Cowl top cover - Heat seal
21. Cowl top cover - Heat seal
22. Cowl top cover - Heat seal




[RH]

1. Evaporator core
2. Joint flange cap
3. Heater lower door
4. Temperature control door
5. Floor door assembly [RH]
6. Vent door assembly [RH]
7. Defogging door assembly [LH]
8. Ventilation guide
9. Heater case [RH]



10. Defogging actuator motor assembly
11. Vent door arm
12. Mode cam
13. Mode actuator motor assembly [RH]
14. PWM blower motor
15. Floor door lever
16. Floor door arm
17. Floor shower duct assembly [RH]
18. Drain hose




    Heater
    ...

    Heater Unit Repair procedures
    Replacement     • Be sure to read and follow the “General Safety Information and Caution” before doing any work related with the high voltage system. Fai ...

    See also:

    Coolant
    The coolant should be changed at the intervals specified in the maintenance schedule. ...

    Battery Management System (BMS) ECU Repair procedures
    Inspection C-CAN Terminating Resistance Inspection (Multi Purpose Check Connector) 1. Turn the ignition OFF. 2. Measure the resistance between pins No. 20 and No. 17 of multi purpose check ...

    Torque Converter Control Solenoid Valve (T/CON_VFS). Inspection
    1. Turn ignition switch OFF. 2. Disconnect the solenoid valve connector (A). 3. Measure resistance bet ...