Removal
1. |
Remove the fuel pump.
(Refer to Fuel Delivery System - "Fuel Pump")
|
2. |
Disconnect the electric pump wiring connector (A) and the fuel sender connector (B).
|
3. |
Remove the head assembly (A) after releasing the cushion fixing clip (B).
|
4. |
Disconnect the fuel tube connector (A).
|
5. |
Remove the reservior-cup (B) after releasing the fixing hooks (A).
|
6. |
Disconnect the fuel tube quick-connector (A).
|
7. |
Release the fixing hooks, and then remove the pre-filter (B).
|
8. |
Remove the fuel pump motor (A).
|
Installation
1. |
Install in the reverse order of removal.
|
Removal
1.
Remove the fuel pump.
(Refer to Fuel Delivery System - "Fuel Pump")
...
Removal
1.
Remove the fuel pump. (Refer to Fuel Delivery System - "Fuel Pump")
...
See also:
Roller Blind Installation
1.
Install the roller blind side bracket (A) fit into the guide groove
(B).
2.
Tighten the mounting screws after installing the ro ...
TJ Joint Inspection
1.
Check the spider assembly for roller rotation, wear or corrosion.
2.
Check the groove inside the joint case for wear or corrosion
...
Rail Pressure Sensor (RPS). Repair procedures
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the RPS at idle and various engine
speed. ...