Kia Soul: Fuel Pressure Control Valve. Repair procedures - Engine Control System - Engine Control / Fuel SystemKia Soul: Fuel Pressure Control Valve. Repair procedures

Kia Soul 2014-2019 PS Service Manual / Engine Control / Fuel System / Engine Control System / Fuel Pressure Control Valve. Repair procedures

Inspection

1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Disconnect the fuel pressure regulator valve connector.
3.
Measure resistance between the fuel pressure regulator valve terminals 1 and 2.
4.
Check that the resistance is within the specification.

Specification: Refer to “Specification”

Removal

Refer to Fuel Delivery System - "High Pressure Fuel Pump"

Installation

Refer to Fuel Delivery System - "High Pressure Fuel Pump"
    Fuel Pressure Control Valve. Schematic Diagrams
    Circuit Diagram (M/T) (A/T) ...

    Canister Close Valve (CCV). Description and Operation
    Description Canister Close Valve (CCV) is normally open and is installed on the canister ventilation line. It seals evaporative emission control system by shutting the canister from the atmo ...

    See also:

    Tire sidewall labeling
    This information identifies and describes the fundamental characteristics of the tire and also provides the tire identification number (TIN) for safety standard certification. The TIN can be use ...

    Injector. Troubleshooting
    Signal Waveform The three waveforms below are taken from the #1 and #4 injectors. The top waveform is from the high side (feed side) of the #1 and #4 injectors, while the middle waveform is ...

    Control Cable Inspection
    1. Check the select cable for proper operation and for damage. 2. Check the shift cable for proper operation and for damage. ...