Kia Soul: Fuel Filler Cap Description - Evaporative Emission Control System - Emission Control System - Kia Soul 2014-2019 PS Service ManualKia Soul: Fuel Filler Cap Description

Second generation PS (2014-2019) / Kia Soul 2014-2019 PS Service Manual / Emission Control System / Evaporative Emission Control System / Fuel Filler Cap Description

A ratchet tightening device on the threaded fuel filler cap reduces the chances of incorrect installation, which seals the fuel filler. After the gasket on the fuel filler cap and the filler neck flange contact each other, the ratchet produces a loud clicking noise indicating the seal has been set.

1. Cover
2. Torsion spring
3. Retainer
4. Gasket seal
5. Spring
6. Plate seal
7. Vacuum valve
8. Spring

    On-board Refueling Vapor Recovery (ORVR) valve Installation
    1. Install in the reverse order of removal. ...

    Fuel Tank Air Filter Removal
    1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Lift the vehicle. 3. Dis ...

    See also:

    Customer Complaint Analysis Check Sheet
    Troubleshooting (Flow chart type) There are six areas where a problem can occur: wiring harness, the radio, the USB/iPod, and speaker. Troubleshooting enables you to confine ...

    Underdrive Brake Control Solenoid Valve(UD/B_VFS). Description
    Underdrive brake control solenoid valve(UD/B) is attached to the valve body. This variable force solenoid valve directly controls the hydraulic pressure inside the underdrive brake. ...

    Knock Sensor (KS). Knock Sensor (KS).
    Removal 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Remove the engine room under cover. (Re ...