Kia Soul: Front Wiper Motor Installation - Windshield Wiper/Washer - Body Electrical SystemKia Soul: Front Wiper Motor Installation

Kia Soul 2014-2019 PS Service Manual / Body Electrical System / Windshield Wiper/Washer / Front Wiper Motor Installation

1.
Install the wiper motor.
2.
Install the crank arm.
  
To install the wiper motor crank arm, make sure that the linkage is aligned with the crank arm in straight line and set the angle of each linkages exactly.
3.
Install the lower and upper linkage to the wiper motor crank arm.
  
To install the wiper motor crank arm, make sure that the linkage is aligned with the crank arm in straight line and set the angle of each linkages exactly.
Be careful not to bend the linkage.
4.
Install the wiper motor and linkage assembly and then connect the wiper motor connector.

Tightening torque:
6.9 ~ 10.8Nm (0.7 ~ 1.1, kgf.m, 5.0 ~ 7.9 lb-ft)

5.
Install the cowl top cover.
6.
Install the windshield wiper arm and blade.

Tightening torque:
22.6 ~ 26.5 Nm (2.3 ~ 2.7 kgf.m, 16.6 ~ 19.5 lb-ft)

  
-
The windshield wiper motor must be cycled to make sure that it is in the auto stop position.
If necessary, adjust the wiper arm and blade.
7.
Install the wiper arm and blade to the auto stop position.
A : Auto stop position (Blade)

    Front Wiper Motor Removal
    1. Loosen the windshield wiper arm nut (B) after removing a wiper cap (A). 2. Remove the windshield wiper arm an ...

    Front Wiper Motor Inspection
    Speed Operation Check 1. Disconnect the connector (A) from the wiper motor. 2. Attach the positive (+) lead from ...

    See also:

    Side repeater lamp (LED type) bulb replacement
    If the side repeater lamp (LED), does not operate, have your vehicle checked by a professional workshop. Kia recommends to visit an authorized Kia dealer/service partner. The LED lamps cannot be ...

    Front Door Inside Handle Repair procedures
    Replacement 1. Remove the front door trim. (Refer to Front Door - "Front Door Trim") 2. Loosen the front door inside handle mounting screws (A). 3. Using a flat-tip screwdriver (B), pull ...

    Rear seat warmer (if equipped)
    The seat warmer is provided to warm the rear outboard seats during cold weather. With the ignition switch in the ON position, push either of the switches to warm rear seats. During mild weath ...